How to Replace the Battery in a 1996 Isuzu Rodeo Key Fob

Remote key fob allow access to your car. If the remote key fob battery is dead you’ll lose your keyless entry fob's ability to use remote functions. Yes, it is possible to replace the battery in your key fob, and it’s easier than you think. Everything you need is explained in this post.
What is the battery remote key fob use
Don't forget before open key fob check all that you need: flat head screwdriver, one CR2025 battery and phillips head screwdriver.- phillips head screwdriver
- flat head screwdriver
- 1xCR2025 battery
Step by step guide
Inside of your remote key fob installed coin battery. Remove fasteners on the back of the key fob. Spin the keyless entry remote over and look for at least 1 screw holding in the plastic.
Delicately try to disassemble your keyless entry remote with flat head screwdriver. Replace 1xCR2025 battery with flat head screwdriver.
Now it's time to install new battery inside keyless entry fob's case. Every battery has a negative and positive side and if you put the wrong connector down, the charge cannot go into your circuit board and make it work. Check polarity on battery, by "+" mark.
After the new battery installed, check remote key fob by pressing buttons. If all functions works, assemble your keyless entry fob's case in reverse order.
At this point squeeze fob’s back cover together. Line your shell two halves together and put it together by hands from top to bottom. Check your remote key fob case for gaps. If it is not tightly closed try to repeat last step. Screw the back of the key fob.
Video of keyless entry remote opening
How To Replace Isuzu Rodeo Key Fob Battery 1996 1997
Still not working? Buy new one