Replace Key Fob Batteries

How to Replace the Battery in a 2006 Chrysler Voyager Key Fob

How to Replace the Battery in a 2006 Chrysler Voyager Key Fob

If your Chrysler key fob isn't open doors well, the battery probably must to be replaced. In this post, you will benefit from knowing how to open Chrysler remote key fob and replace a weak or dead battery DIY. If you decide to do it at home near Voyager, follow our guide, but first make sure you have all you need.

What size battery does 2006 Chrysler Voyager keyless entry remote take

Before you start to open remote key fob check all that you need: 1xCR2032 battery and flat head screwdriver.
  • flat head screwdriver
  • 1xCR2032 battery

Simple steps to replace the battery in your car's key fob

A tiny coin cell battery installed inside the your remote key fob. Delicately try to disassemble your fob with pry tools. Change 1xCR2032 battery with flat head screwdriver.

Now it's time to install new battery in keyless entry fob's shell. Every battery has a negative and positive side and if you put the wrong connector down, the charge cannot go into your circuit board and make it work. Check polarity on battery, by "+" mark.

When the new battery installed, check keyless entry remote functionality by pressing buttons. If everything working properly, assemble your keyless entry fob's body in reverse order.

At this point squeeze keyless entry fob's back cover together. Line your shell two halves together and put it together by hands from top to bottom. If your key fob case firmly closed, we done. If not, repeat the last step.

Key Fob Battery Replacement 2006 Chrysler Voyager Video

Chrysler Voyager Key Fob Battery Replacement (2004 - 2007)

Still not working? Buy new one

Frequently Asked Questions

Remote key fob of Chrysler Voyager require 1xCR2032 batteries. Price for CR2032 batteries are under $5 build upon the size packaging, type and brand you buy. Take your old battery to the store, to be sure.

Remote key fob in most of cases do not need to be reprogrammed after battery replace. If your remote key fob not working, recheck new battery voltage. Otherwise, read user's manual or contact local dealer.

Yes, you can replace battery in your 2006 Chrysler Voyager key fob yourself. Most difficult part is to open keyless entry fob's case. It's pretty easy with our step by step guide.

The price to replace the battery inside key fob is from $30 to as high as $500 depending on the brand and the service station.

You should replace batteries inside key fob of modern cars at least once in three or four years. lifespan of battery differ on their amount of use, quality and operating conditions. Lithium cells normally will last longer.

These signs will warn you that it's perhaps time to change battery in your 2006 Chrysler Voyager: key fob buttons not working, signal strength reduced, you didn't change battery more than 4 years and low key battery indicator on dashboard.
Be the first to comment.
Your message is required.

Contents:

  1. Battery Size and Tools
  2. Replacement Guide
  3. Video Instruction
  4. FAQ

Other Chrysler Models:

Fob Compatibility:

  1. FCC ID: OHT692714AA
  2. Models: 2004-2007 Chrysler Voyager