2006 Toyota Sienna Key Fob Battery Replacement Instructions

2006 Toyota Sienna Key Fob Battery Replacement Instructions

If your car keyless entry remote isn't working properly, the cell battery most likely needs to be replaced. Yes, it is possible to replace the battery in your key fob DIY. All you need is outlined in this article.

What is the battery keyless entry remote require

Before beginning disassembly keyless entry remote check all that you need: flat head screwdriver, phillips head screwdriver and 1xCR2032 battery.
  • phillips head screwdriver
  • flat head screwdriver
  • 1xCR2032 battery

Simple steps to replace the battery in your Sienna's remote key fob

A small coin battery installed inside the your key fob. Remove fasteners on the back of the key fob. Spin the key fob over and look for at least 1 fastener holding in the plastic.

Delicately try to pry apart your remote key fob with flat head screwdriver. Remove 1xCR2032 battery with flat head screwdriver.

Get new battery and install it inside fob’s shell. Battery must be placed with the same position as was a previous. Your remote key fob will not work if you mistakenly put battery wrong way.

After the new battery installed, check remote key fob functionality by pressing buttons. If all functions works, assemble your keyless entry fob's shell in reverse order.

At this point squeeze keyless entry fob's back cover together. Line your shell two halves together and put it in place by hands from top to bottom. If your fob shell tightly closed, we done. If not, repeat the last step. Screw fastener in the back of the keyless entry remote.

Key Fob Battery Replacement 2006 Toyota Sienna Video

▶️How To Change Toyota SIENNA Remote Battery Replacement ( NO TOOLS NEEDED)

Still not working? Buy new one


Remote key fob of Toyota Sienna use 1xCR2032 batteries. Price for CR2032 batteries are under $4-6 build upon the type, size packaging and brand you buy. Take your old battery to the store, to be sure.

Key fob in most of cases reprogramming not required after battery change. If your key not working, recheck new battery voltage. Otherwise, read user's manual or contact local dealer.

Yes, you can change battery in your 2006 Toyota Sienna remote key fob yourself. Most hard part is to open fob’s case. It's pretty simple with our guide.

Dealer service pricing for change the battery in remote key fob is from 50 to 600 dollars depending on the make.

You should change batteries inside key fob of Toyota Sienna at least once in 3-4 years. The term of battery vary on their amount of use, operating conditions and quality. Famous brands cells normally will last longer.

These symptoms will alert you that it's perhaps time to change battery in your Toyota Sienna: multiple clicks to unlock or lock doors required, low key battery indicator on dashboard, signal strength reduced and you didn't change battery more than 4 years.
Be the first to comment.
Your message is required.

Fob Compatibility:

  1. FCC ID: GQ43VT20T
  2. Models: 2004-2018 Toyota Sienna