How to Jump Start a Toyota Prius (Every Generation)
To jump start a Prius, open the hood and unclip the fuse box cover to find the red-capped jump terminal marked “+”. Clamp red there and black to bare metal on the engine or body, then turn on the jump pack or donor car. Press the brake and the Power button until READY lights. Leave it in READY for about 30 minutes.
When a Prius will not wake up, the problem is almost always the small 12V auxiliary battery, not the large hybrid battery. The 12V battery powers the computers, the door locks and the relays that connect the hybrid system. When it is flat, the car stays dark even though the big battery is fine.
That is good news: a Prius needs only a small amount of power to get to READY. There is no starter motor cranking a cold engine the way a regular car does, so even a small jump pack or compact car works.

Where Is the 12V Battery on a Prius?
| Generation | Years (US) | Typical 12V location | Jump point |
|---|---|---|---|
| 2nd gen | 2004-2009 | Rear cargo area, right side | Jump terminal in under-hood fuse box |
| 3rd gen | 2010-2015 | Rear cargo area, right side | Jump terminal in under-hood fuse box |
| 4th gen | 2016-2022 | Varies by trim; check manual | Jump terminal in under-hood fuse box |
| 5th gen | 2023 and newer | Check manual | Under-hood jump terminal or battery |
| Prius c / Prius v | Various | Varies by model | Under-hood jump terminal |
Toyota put the jump terminal under the hood because the rear hatch on many Prius models needs power to open. Our guide to jump starting a hybrid car explains the same layout on other Toyota and Lexus hybrids.
What You Need
- A small jump pack or a donor car with a 12V battery.
- Jumper cables, if using a donor car.
- Safety glasses.
- The Prius smart key (its battery should also be working; see below).
Compact lithium jump starter
A small 12V pack in the 400 to 1000 peak amp range is plenty for a Prius, because it only needs to power the electronics to reach READY.
As an Amazon Associate, ReplaceKeyFob earns from qualifying purchases.
Why the Prius 12V Battery Goes Flat
Knowing the cause helps you avoid the next jump:
- Short trips only. The 12V battery charges only in READY, and a 5-minute drive barely replaces what unlocking and starting used.
- Car parked for two weeks or more. Modules, the alarm and the keyless entry system draw a small current all the time.
- Leaving the car in accessory mode with the radio or a dash camera running.
- An interior light or hatch left open, which keeps lights on and modules awake.
- Age. The small AGM battery wears out on schedule regardless of use.
If the car will sit, a small maintainer at the jump terminal keeps the 12V healthy. See how to keep a car battery charged.
Step 1: Get Into the Car
With a dead 12V battery, the smart key will not unlock the doors. Slide the mechanical key out of the fob and use the key slot in the driver’s door handle. On some models the slot is hidden under a small cap on the handle; pry it off gently from the bottom.
The alarm may sound when you open the door. It will stop once the car has power and you press the Power button with the key inside.
Step 2: Open the Hood
Pull the hood release lever under the dashboard on the driver’s side, then lift the hood and release the safety catch. If the release feels stuck, our guide on opening a hood with a dead battery helps.
Step 3: Find the Jump Terminal
- Locate the main fuse box in the engine compartment (a black plastic box, usually on the driver side).
- Unclip the cover.
- Look for a red plastic cap marked “+”. Lift it to expose the metal jump terminal.

Step 4: Jump the Prius
With a jump pack
- With the pack off, clamp red to the jump terminal.
- Clamp black to a bare metal ground, such as an unpainted engine bolt or a body ground point. Do not use any orange cable or component.
- Turn the pack on.
- Get in the car with the smart key, press and hold the brake, and press the Power button.
- Wait for the READY light on the dash. The gas engine may or may not start; that is normal.
- Turn the pack off and remove black, then red.
- Close the red cap and the fuse box cover.
With a donor car
- Both cars off.
- Red to the Prius jump terminal.
- Red to the donor battery positive.
- Black to the donor battery negative.
- Black to bare metal on the Prius.
- Start the donor and let it run a few minutes.
- In the Prius, press brake and Power until READY.
- Remove cables in reverse order.
Step 5: Recharge the 12V Battery
A Prius charges its 12V battery from the hybrid system, not from an alternator. It only charges while the car is in READY.
- Leave it in READY for at least 30 minutes with lights and HVAC off, or drive it.
- Park in a safe, ventilated place if you leave it in READY while stopped; the gas engine may start on and off to charge the hybrid battery.
- Use a charger if the battery was very flat. A smart charger with an AGM mode is ideal, connected at the jump terminal and ground, or directly at the battery.
How to Jump Start a 2012 Prius (3rd Generation)
On a 2010-2015 Prius, the 12V battery is in the rear cargo area under a side panel on the right. You do not need to reach it. Use the jump terminal in the under-hood fuse box, ground to bare metal, then press brake and Power for READY. The same steps cover a 2015 Prius.
Can a Prius Jump Start Another Car?
Toyota generally advises against using a hybrid to jump another vehicle. The Prius 12V battery is small and the DC converter that charges it is not built to feed a large starter motor. Many Prius manuals specifically say not to. If you need to help another car, use a jump pack instead.
Prius Won’t Start After a Jump?
| Symptom | Likely cause | What to do |
|---|---|---|
| Dash lights, no READY | Brake not pressed, key not detected | Press brake firmly; hold key to Power button |
| “Key not detected” | Smart key battery low | Hold the key against the Power button and press it |
| READY, then shuts off | 12V battery too weak | Charge or replace 12V battery |
| Check hybrid system warning | Low-voltage fault or real hybrid issue | Restart; scan codes if it stays |
| No power at all with pack on | Poor clamp contact | Clean jump terminal; move ground |
If the car does not see the key, the backup method is simple: hold the smart key logo side against the Power button and press it with the brake down. Our guide on Prius key not detected covers it in more detail.
Safety Notes for Hybrids
- Never touch orange cables or components. They carry high voltage.
- Never try to jump the hybrid battery. Only the 12V system gets jumped.
- Do not clamp a battery that is swollen, cracked or leaking.
- Keep the pack or cables away from the cooling fan, which can turn on by itself.
Mistakes to Avoid
- Expecting cranking. If READY lights, the car is started even if the engine is quiet.
- Turning it off right away. The 12V battery needs time in READY to recover.
- Using a big truck pack in boost mode. It is not needed; a small pack is safer.
- Replacing the wrong battery. A no-start is almost never the hybrid pack.
When to Replace the 12V Battery
The Prius 12V battery commonly lasts about 4 to 6 years. If it needs a jump more than once, or reads under 12.4V after a full charge and rest, replace it. In 2026 a Prius 12V AGM battery typically costs about $180 to $300, plus about $50 to $150 labor at a shop. Our guide on how to replace a 12V battery in a hybrid walks through the DIY job, and Prius-compatible OBD2 tools can show 12V and hybrid data.
Frequently Asked Questions
In the main fuse box under the hood, under a red cap marked “+”. Clamp red there and black to bare metal on the engine or body.
Open the hood, open the fuse box cover, clamp red to the jump terminal and black to bare metal, power the pack or donor, then press brake and Power until READY.
Yes. The 12V battery powers the computers and relays that connect the hybrid system. When it is flat, the car will not reach READY even if the hybrid battery is full.
At least 30 minutes, with accessories off, or drive it. The 12V battery only charges while the car is in READY.
Toyota generally advises against it, because the Prius 12V battery and converter are not built to feed another car’s starter. Use a jump pack instead.
