How to Jump Start a Mercedes-Benz (Cars, SUVs and Sprinter)

Quick Answer

To jump start a Mercedes, open the hood and find the jump-start positive terminal under a red cap, then connect red there and to the donor positive, black to the donor negative, and black to the marked ground point under the hood. Do not connect to the small auxiliary battery. Start the donor, then the Mercedes.

Mercedes-Benz places the main 12V battery in different places depending on the model: under the hood, in the trunk, or under the front passenger floor on several SUVs. To make jumping simple, most models have a dedicated jump-start terminal and ground point in the engine compartment. Many also carry a small auxiliary battery that supports electronics and start-stop, and that one must never be used for jumping.

Here is how to find the right points, jump the car safely, and deal with the messages the car may show afterward.

Mercedes Jump Checklist: how to jump start a mercedes summary card

Where Is the Battery on Common Mercedes Models?

Model Typical main battery location Jump connection
C-Class Under the hood or in the trunk, by generation Under-hood jump terminal on most
E-Class (E350 and others) Trunk, under the floor on many generations Under-hood jump terminal and ground
S-Class Trunk Under-hood jump terminal and ground
ML / GLE (ML350 and others) Under the front passenger floor on many generations Under-hood jump terminal and ground
GL / GLS Under the front passenger floor or seat area Under-hood jump terminal
GLC, GLA, CLA Under the hood on many Battery or jump terminal under the hood
Sprinter van Under the driver floor on many 2007-2018 vans Under-hood jump points on many

Check the “Jump-starting” section of your owner’s manual for the exact diagram. On newer models, the digital manual in the MBUX screen or the Mercedes app has the same pages.

What You Need

  • A donor car with a 12V battery, or a jump pack.
  • 4 to 6 gauge jumper cables.
  • Safety glasses.
Backup plan

Jump starter for European cars

A lithium pack in the 1500 to 2500 peak amp range with long cables reaches under-hood jump terminals easily on most Mercedes gas and diesel engines.

Check Price on Amazon →

As an Amazon Associate, ReplaceKeyFob earns from qualifying purchases.

How to Find the Mercedes Jump Points

  1. Open the hood.
  2. Look for a red cap marked “+” near the fuse box or along the side of the engine bay. Under it is the jump-start positive terminal.
  3. Find the ground point: a marked nut, bolt or bracket labeled “-” or shown in the manual, often on the body near the positive terminal or on the engine.
  4. If the battery is under the hood (some C-Class, GLC, GLA, CLA), you can clamp the battery positive directly, but still use the engine ground for the black clamp.

How to Jump Start a Mercedes With Cables

  1. Switch everything off. Turn the ignition off and remove the key or make sure the keyless start is off. Switch off lights, HVAC and radio.
  2. Position the donor car close to the Mercedes, engine off.
  3. Red to the Mercedes jump-start positive terminal.
  4. Red to the donor’s battery positive.
  5. Black to the donor’s battery negative.
  6. Black to the Mercedes ground point.
  7. Start the donor and let it run for a few minutes.
  8. Start the Mercedes. Crank for no more than about 10 to 15 seconds. If it does not start, wait about 2 to 3 minutes before trying again.
  9. Let both cars run for a few minutes, then remove cables in reverse order: black from the Mercedes, black from the donor, red from the donor, red from the Mercedes.
Mercedes Jump Steps: how to jump start a mercedes step card

The Auxiliary Battery: Leave It Alone

Many Mercedes models have a smaller auxiliary or backup battery in addition to the main battery. It supports start-stop, electronic systems or the transmission park lock. It is not built for jumping.

  • Do not clamp jumper cables to the auxiliary battery.
  • Do not use it to jump another car.
  • If you see an “Auxiliary battery malfunction” message, it relates to that small battery, not the main one. A jump will not fix it.

How to Jump Start a Mercedes E350

On many E-Class generations, the battery sits in the trunk. Open the hood and use the jump-start terminal and ground point as above. If the trunk will not open because of the dead battery and you need something stored there, our guide on how to open a Mercedes trunk from inside explains the manual options.

How to Jump Start a Mercedes ML350

On many ML generations, the main battery is under the front passenger floor. Do not lift the carpet to reach it. Use the under-hood jump-start terminal and ground point. After the jump, the air suspension (on equipped models) may need a few minutes to level the vehicle.

How to Jump Start a Mercedes Sprinter Van

Sprinters vary by generation and by upfit:

  • On many 2007-2018 Sprinters, the main battery is under the driver’s floor, with jump points under the hood. Use those points.
  • Many Sprinters have a second (auxiliary) battery for the cargo area or camper equipment. Do not jump from that battery unless it is an engine-start battery in your setup.
  • Diesel Sprinters need the glow plug light to go out before cranking in cold weather.

The diesel tips in our guide on how to jump start a truck apply to Sprinter diesels too.

Using a Jump Pack on a Mercedes

  1. With the pack off, clamp red to the jump-start positive terminal and black to the ground point.
  2. Turn the pack on and wait for the ready light.
  3. Start the Mercedes.
  4. Turn the pack off, then remove black, then red.

See how to use a jump starter for general steps.

After the Jump

  • Messages on the dash: “Stop vehicle, leave engine running” or electrical messages sometimes appear when voltage is low. If the engine runs normally and the message clears after a drive, it was the low voltage. If it stays, have it scanned. A Mercedes-capable OBD2 scanner reads the main modules.
  • Windows and sunroof: may need re-initializing. Run each window fully down, then fully up and hold for a couple of seconds.
  • Key not detected: if the KEYLESS-GO key is not recognized after a jump, see Mercedes key fob not working for the backup start method and battery checks.
  • Drive at least 30 minutes or use a smart charger at home.
See also  How to Start a Car That Has Been Sitting for Months (or Years)

Charging a Mercedes Battery at Home

Driving after a jump helps, but a deeply flat AGM battery recovers far better on a charger. Mercedes manuals generally allow charging through the same under-hood jump-start terminal and ground point, so you do not need to reach a battery under the floor.

  1. Use a smart charger with an AGM mode.
  2. Connect red to the jump-start terminal and black to the ground point.
  3. Charge until the charger shows full, which can take several hours to overnight.
  4. Disconnect the charger before starting the car.

Avoid fast “boost” or engine-start modes on older chargers, which can overheat an AGM battery. Our guide on how to charge a car battery at home covers charger settings.

Can a Mercedes Jump Another Car?

Most Mercedes manuals allow it through the same jump-start terminal and ground point. Keep the Mercedes engine running, connect red to red and black to the other car’s ground, and let it run a few minutes before the other car cranks. Do not use the auxiliary battery, and do not jump a vehicle with a 24V system.

Troubleshooting

Symptom Likely cause Fix
Nothing happens Clamps on wrong point or poor ground Recheck manual diagram
Clicking Very flat battery, poor contact Let donor run 5 to 10 minutes; reseat ground
Starts, aux battery message Auxiliary battery weak Have the auxiliary battery tested
Starts, dies again Main battery or alternator fault Test battery and charging voltage
Warning messages stay on Stored low-voltage faults Scan and clear codes

Mistakes to Avoid

  • Clamping the auxiliary battery.
  • Lifting floor panels to reach a battery under the passenger floor when jump terminals are provided.
  • Grounding to a painted or plastic-mounted part.
  • Cranking for long periods; Mercedes manuals recommend short attempts with rests.

Battery Replacement Cost

If the main battery is weak or more than about 5 years old, replace it. In 2026 a Mercedes AGM battery typically costs about $220 to $400 for the part, and about $350 to $700 installed, depending on location and whether coding or registration is done. An auxiliary battery is cheaper but labor varies by model.

Frequently Asked Questions

Where are the jump points on a Mercedes?

Most models have a jump-start positive terminal under a red cap in the engine compartment and a marked ground point nearby. The owner’s manual shows the exact location.

How do you jump start a Mercedes Sprinter van?

Use the jump points under the hood if your van has them, clamp red to positive and black to the ground point, and cycle the glow plug light on diesel models before cranking.

Can I jump start a Mercedes using the auxiliary battery?

No. The auxiliary battery is a small backup battery for electronics and is not designed for jump starting.

Where is the battery on a Mercedes ML350?

On many generations it is under the front passenger floor. Use the under-hood jump terminal instead of reaching the battery directly.

Why does my Mercedes show warning messages after a jump?

Low voltage causes modules to log temporary faults. Most clear after driving and restarting. If messages stay, have the codes read.

Author

  • ReplaceKeyFob Editorial Team

    The ReplaceKeyFob Editorial Team researches and writes practical guides on key fob batteries, smart keys, keyless entry problems and basic car electronics. Every guide is checked against manufacturer owner's manuals, battery maker specifications (CR2032, CR2025, CR1632 and others) and real-world troubleshooting before it is published, and we update articles when vehicle models or procedures change. Spotted an error? Contact us and we will review it.