How to Open a Locked Car Trunk Without the Key

Quick Answer

To open a locked car trunk, first try the trunk button on the fob (often a double press or long hold) and the release lever or button by the driver seat. If those fail, fold the rear seats forward, reach into the trunk and pull the glow-in-the-dark emergency release handle. A locksmith is the last resort.

A trunk that will not open is rarely a lost cause. Most cars give you three or four separate ways in: the remote, a cabin release, the rear seat pass-through, and an interior emergency handle that every car sold new in the US since the 2002 model year must have. You only need one of them to work.

This guide is about getting into a trunk that is locked or will not release. If you are already inside the trunk, or want to find the release from the cabin, read how to open a car trunk from inside. If the whole car is locked and the keys are lost, start with how to unlock a car when the key is lost.

Ways Into a Locked Trunk: how to open a locked car trunk summary card

Why a Trunk Stays Locked

Knowing the cause tells you which method will work. Most trunks stay shut for one of these reasons:

Cause Clue Best first move
Car is still locked Doors locked, alarm armed Unlock all doors, then retry
Weak fob battery Doors also slow to respond Hold fob closer, replace coin cell
Dead 12V car battery No dome light, no chirp Jump or charge the car battery
Valet or trunk lockout mode Cabin button does nothing Unlock with the mechanical key
Broken release cable or actuator Click but lid stays shut Interior emergency handle
Frozen latch or seal Cold weather, lid pops slightly Warm the car, push down then release

Many cars ignore the cabin trunk button while the car is locked or while the car is moving above a walking pace. Unlock the doors first and put the transmission in Park.

Method 1: The Key Fob and Cabin Release

Start with the easy options, because they fix most cases.

  1. Unlock the whole car. Press unlock twice on many models to unlock all doors, not just the driver door.
  2. Press the fob trunk button correctly. Many fobs need a double press or a one-second hold so a pocket bump does not open the lid. If nothing happens, see key fob trunk button not working.
  3. Find the cabin release. It is usually a lever on the floor beside the driver seat, a button on the lower dash left of the steering wheel, or a button on the driver door panel. Pull or press it while someone watches the lid.
  4. Listen. A click or buzz from the back means the actuator is getting power. If you hear it but the lid stays shut, the latch or rod is stuck, not the electrics.

If the fob and cabin button both do nothing and the dome light is dead, the 12V battery is the likely cause. Jump or charge it, then try again. Our guide on how to jump start a car covers the safe cable order.

Method 2: Use the Mechanical Key

Most smart keys hide a metal blade. Slide the release on the fob and pull it out.

  • Older sedans have a lock cylinder in the trunk lid, often beside the license plate light or under the emblem. Turn the key toward the driver side on many cars to release the lid.
  • Newer cars often have no exterior trunk keyhole at all. The blade still unlocks the driver door, which lets you use the cabin release or fold the seats.
  • Valet mode: some cars, including many luxury sedans, let you lock the trunk separately with the key or a glove box switch. If the trunk was locked that way, the cabin button will not open it until you unlock it with the same key or switch.
Locked Trunk Checklist: how to open a locked car trunk step card

Method 3: Go Through the Rear Seats

This is the method that saves most people a locksmith bill.

  1. Open a rear door and look at the top corners of the rear seatback for a pull tab, button or lever. Some cars have a strap at the seat base instead.
  2. Release one side and fold that section forward. A 60/40 split seat gives you plenty of room on the larger side.
  3. If the seat will not fold, check the trunk side of the seat on the car’s diagrams in the owner’s manual. Some sedans only release the seatbacks from inside the trunk, which does not help here. In that case, check for a center armrest pass-through (ski hatch) instead.
  4. Use a flashlight and reach or crawl toward the latch.

On a hatchback or SUV the cargo area is already open to the cabin, so you can climb over the seat and reach the liftgate trim directly.

Method 4: Pull the Interior Emergency Release

US safety rules (FMVSS 401) require an internal trunk release on passenger cars with a trunk, built from the 2002 model year on. It is almost always a T-shaped or round handle near the latch that glows in the dark, often with a trunk-and-person icon.

  1. Once you can reach the inside of the trunk, look at the center of the lid, near the latch.
  2. Pull the handle firmly toward you or down. It works the latch mechanically, so it opens even with a dead battery or a failed actuator.
  3. If the handle moves but the lid stays shut, push the lid upward with your other hand while you pull. A tight latch sometimes needs the pressure taken off it.

SUVs and hatchbacks: liftgates are not covered by the same rule, but many have a manual release. Look for a small rectangular cover or hole in the inside liftgate trim panel. Pop it out and push the lever or rod behind it with a screwdriver.

Method 5: When the Lid Opens a Little but Not Fully

If the lid pops up an inch and stops, something is holding it. Common causes are a strap or cargo item jammed against the lid, a frozen seal, or a power trunk motor fighting a manual pull. On power trunks, do not force the lid upward against the motor. Press the button again and let the motor finish, or switch the power function off in the vehicle settings and open it by hand. For ice, warm the car with the heater running for 15 minutes, push down on the lid to crack the seal, then release again.

Picking a Trunk Lock: Why It Is a Bad Idea

Videos make picking a trunk lock look easy. In practice, modern wafer locks resist simple picks, and forcing a screwdriver into the cylinder can destroy it, turning a free fix into a $150 to $400 repair. Only ever work on your own car, and use non-destructive methods first.

If you need tools, use them on a door, not the trunk. A wedge and reach rod can open the driver door so you can use the cabin release or seat pass-through. Modern doors carry side airbag sensors, wiring and window cables, so go slowly and avoid stabbing tools down inside the door. Our guide on how to unlock a car door with a coat hanger explains which cars this still works on.

Troubleshooting Table

What happens Likely problem Fix
Nothing from fob or cabin button, no lights Dead 12V battery Jump, charge or replace battery
Click at the trunk, lid stays shut Sticky latch or bad actuator Push lid down, then release; lube latch
Cabin button works, fob does not Fob battery or fob button Replace coin cell, test fob
Nothing works, car is unlocked Trunk lockout or blown fuse Check valet switch and trunk fuse
Handle inside moves, lid stuck Jammed load or frozen seal Push up while pulling, warm the car

A blown fuse is easy to miss. Check the fuse box diagram for a fuse labeled trunk, rear lid, liftgate or similar, and replace it with the same amp rating.

Mistakes to Avoid

  • Prying the lid edge. A flat bar bends the lid and chips paint. Repairs cost far more than a locksmith.
  • Cutting the release cable. The cable is the backup, not the problem.
  • Ignoring the battery. Many “broken trunk” calls are really a flat car battery.
  • Letting children play near the trunk. Show kids the glowing release, and keep the car locked so they cannot climb in.

When to Call a Locksmith or Shop

Call a pro if none of the methods work, if the seats cannot be folded, or if the car is badly locked out. Typical 2026 US costs are about:

  • Locksmith trunk or car lockout: about $75 to $250, higher at night
  • Roadside assistance: often free with a plan or insurance
  • Trunk latch or actuator replacement: about $150 to $400 at a shop
  • Trunk lock cylinder repair: about $150 to $350

A locksmith or dealer will ask for proof of ownership, such as your registration and ID. Keep a photo of both on your phone. If the trunk keeps failing, our guide on why a key fob opens the trunk but not the doors covers related lock faults.

Frequently Asked Questions

How do I open a locked trunk if my car battery is dead?

Unlock the driver door with the key blade, then fold the rear seats and pull the interior emergency release, which is mechanical. Or jump-start the car so the cabin button works again.

Can I open my trunk from the back seat?

Often yes. Fold one section of the rear seatback forward using the pull tab or button at the top of the seat, reach into the trunk and pull the glowing release handle.

Why won’t my trunk open with the button?

Common causes are a locked car, a weak fob battery, a blown trunk fuse, a failed actuator or the trunk being locked separately in valet mode.

Where is the keyhole for my trunk?

On older cars it is in the trunk lid near the plate light or under the badge. Many newer cars have no trunk keyhole, so use the key to open the driver door instead.

How much does a locksmith charge to open a trunk?

Typically about $75 to $250 in the US in 2026, depending on time of day and location. Roadside assistance plans may cover it.

Is it legal to open a trunk with lockout tools?

It is legal on your own vehicle. Never use these methods on a car you do not own or have permission to open.

Author

  • ReplaceKeyFob Editorial Team

    The ReplaceKeyFob Editorial Team researches and writes practical guides on key fob batteries, smart keys, keyless entry problems and basic car electronics. Every guide is checked against manufacturer owner's manuals, battery maker specifications (CR2032, CR2025, CR1632 and others) and real-world troubleshooting before it is published, and we update articles when vehicle models or procedures change. Spotted an error? Contact us and we will review it.