How to Open a Jeep Hood (Wrangler, Grand Cherokee and More)
To open a Jeep hood on a Wrangler or Gladiator, pull up the two rubber or metal hood latches on the outside of each fender, then reach under the front edge of the hood and push the safety catch. Grand Cherokee, Cherokee, Compass and Renegade work like most cars: pull the release lever under the dash on the driver side, then release the front safety catch.
Jeep has two very different hood designs. The Wrangler and its pickup sibling, the Gladiator, keep a classic off-road look with exposed latches on the sides of the hood and no lever inside the cabin. The rest of the lineup, built on car-like platforms, uses a normal interior release. If you have driven only one type, the other can be confusing the first time.
This guide covers each Jeep model, how to support and close the hood, and what to do if it will not open. For the basics that apply to every car, see how to open a car hood.

Jeep Hood Release by Model
| Model | Release method | Hood support |
|---|---|---|
| Wrangler JL (2018+) | Two outside side latches, then safety catch | Prop rod on many |
| Wrangler JK (2007 to 2018) | Two outside rubber latches, then safety catch | Prop rod |
| Wrangler TJ and YJ (1987 to 2006) | Outside metal latches, then safety catch | Prop rod |
| Gladiator (2020+) | Same as Wrangler JL | Prop rod on many |
| Grand Cherokee (WK2 and WL) | Lever under dash, driver side, then catch | Gas struts on many |
| Cherokee (KL, 2014 to 2023) | Lever under dash, then catch | Prop rod on many |
| Compass and Renegade | Lever under dash, then catch | Prop rod on many |
The hood support type can differ by trim and year. Look before you let go of the hood.
How to Open a Wrangler or Gladiator Hood
- Park and shut off the engine. Set the parking brake.
- Find the side latches. On each side of the hood, near the windshield end of the fender, there is a latch. On a JK it is a thick rubber strap with a hook; on a JL and Gladiator it is a rubber or metal latch that flips up.
- Release both latches. Pull the bottom of each latch outward and up until it unhooks from the hood. Do one side, then the other.
- Find the safety catch. Go to the front. Reach under the center of the hood’s front edge, behind the grille. Feel for a small lever.
- Push the catch. Push the lever to the side while lifting the hood. On some models you can see it through the grille slots with a flashlight.
- Prop the hood. Raise it fully and set the prop rod in its marked slot.
There is no interior hood lever on a Wrangler or Gladiator, so do not spend time searching the footwell.
Closing a Wrangler hood
- Remove the prop rod and clip it back in place.
- Lower the hood to about a foot above the grille and let it drop so the safety catch engages.
- Hook both side latches back over the hood and press them down until they seat.
Driving with the side latches open lets the hood flutter at speed. Always relatch both sides.
Locking Hood Latch Kit
Wrangler hoods are easy to open from outside, which makes them easy for thieves to open too. A locking hood latch kit replaces the stock latches with keyed locks. Check that it lists your exact generation (JK, JL or Gladiator).
As an Amazon Associate, ReplaceKeyFob earns from qualifying purchases.

How to Open a Grand Cherokee, Cherokee, Compass or Renegade Hood
- Find the lever. Look under the dashboard to the left of the steering column, low near the driver’s left knee or by the door. It has an open-hood icon.
- Pull it firmly. The hood pops up about an inch with a thud.
- Find the safety catch. At the front, slide your fingers under the center of the hood edge and feel for a lever.
- Push or lift the catch while raising the hood.
- Support the hood. Gas struts hold it up on many Grand Cherokees. On models with a prop rod, set the rod in the marked slot.
Close it properly
Lower the hood to about 12 inches and let it drop. If it does not latch, lift and drop from slightly higher. Do not press down on the middle with your palms; that dents the hood.
Jeep Renegade and Compass Notes
These smaller Jeeps share parts with other Stellantis models. The safety catch is under the front edge, and on some trims it is slightly off center. Use a flashlight through the grille if you cannot feel it. The hood is light, so a prop rod is common.
Jeep Hood Will Not Open?
| Symptom | Model type | Fix |
|---|---|---|
| Hood will not lift after releasing latches | Wrangler, Gladiator | Check both side latches are fully unhooked |
| Safety catch will not move | All | Spray lube on the catch, work it gently |
| Lever pulls with no resistance | Interior lever models | Cable off the lever or snapped |
| Lever stiff, hood stays down | Interior lever models | Have a helper pull while you press down on hood |
| Side latch torn or missing | Wrangler, Gladiator | Replace latch; drive slowly until fixed |
Wrangler rubber latches crack with age and sun. A torn latch is an easy, cheap part. For a broken cable on interior-lever Jeeps, see how to open a car hood with a broken latch.
Why You Might Open the Hood
- Jump starting. Jeep batteries are under the hood on most models. Follow the safe order in how to jump start a car.
- Battery checks. Look for corrosion; see battery terminal corrosion.
- Fluids. Oil, coolant, brake fluid and washer fluid are all checked here.
- Key fob or electrical problems after battery work. Some Jeeps need a fob resync; see Jeep key fob battery replacement for remote issues.
How to Replace a Worn Wrangler Hood Latch
The stock rubber latches on a JK, and the latches on a JL or Gladiator, wear out with sun and use. Replacing one is a 10-minute job.
- Open the hood and support it.
- Find the latch base on the fender side. It is held by two small bolts or Torx screws, often reached from under the hood edge.
- Remove the old latch and fit the new one in the same position.
- Check that the catch on the hood side is not cracked or loose; it is sold separately on some kits.
- Close the hood and test the latch tension. It should pull the hood down firmly with no gap.
Buy latches made for your exact generation. JK and JL parts are not interchangeable.
Off-Road and Weather Tips
- Mud and water crossings: check that both Wrangler latches are fully seated before you go. A latch that pops loose at speed lets the hood lift.
- Snow and ice: rubber latches stiffen in the cold. Warm them with your hands or let the engine run a few minutes before pulling hard.
- Aftermarket hoods: vented or performance hoods may use pin latches or different catches. Follow the hood maker’s instructions.
- Security: because Wrangler latches are outside, anyone can open the hood. Many owners add locking latches to protect the battery and engine parts.
Mistakes to Avoid
- Hunting for a cabin lever on a Wrangler. There is none.
- Prying the safety catch with a screwdriver before the main latch has released.
- Driving with one side latch open. The hood can lift and crack the windshield.
- Slamming the hood instead of dropping it from a foot.
When to Get Help and What It Costs
If the hood will not open after these steps, a Jeep dealer or independent shop can open it from underneath. Typical 2026 US costs are about:
- Wrangler hood latch pair: about $20 to $80 for parts
- Locking hood latch kit: about $80 to $250 for parts
- Hood release cable (non-Wrangler): about $100 to $300 installed
- Hood latch replacement: about $150 to $400 installed
If your Jeep also has key or start problems, our guide to Jeep lost car key explains your options.
Frequently Asked Questions
There is no interior lever. Flip up the two hood latches on the outside of each fender, then push the safety catch under the front edge of the hood.
The same as a Wrangler JL: release the two side latches, then the safety catch under the front center of the hood, and set the prop rod.
Pull the release lever under the dashboard on the driver side, then reach under the front edge of the hood and push the safety catch.
Under the dashboard to the left of the steering column, low on the driver side. Pull it, then release the safety catch at the front.
One side latch may still be hooked, or the safety catch may be stiff. Check both latches and spray lube on the catch.
